| California Robotics and Automation

OPTEK 156 CONVERTER

Jerry Bransom — Mon, 26 Jun 2023 23:00:50 +0000

The converter is exclusively to be used as a converter for optek-sensor assemblies according to the technical data. In connection with the inline sensors for turbidity, concentration and color, the converter is used for displaying and processing of measuring results. The converter is only applicable for sensors listed in the chapter "Technical data". The converter is to be installed in a control cabinet, which provides an external release device so that the converter can be switched voltage-free. Observe chapter "Technical data". The use in explosion proof areas is prohibited. Unauthorized constructional changes, additional fittings or rebuildings as well as changes to and interference with the converter program are prohibited. The manufacturer is not liable for damage resulting from use contrary to intended use. Following this instruction manual is part of the intended use.

HMI Software for our machines (Call or Email for Password)

Jerry Bransom — Thu, 20 Oct 2022 14:32:42 +0000

HMI Software for EZ3 Series 7″ Wide TFT Color – EZ3-T7C-E

AS Language Manual for E Controller

Jerry Bransom — Thu, 20 Oct 2022 14:26:48 +0000

If you are planning on programming the robot using your laptop, this is the manual of all commands. If you have a copy of an AS Language program, you can use this to explain it.

Kawasaki KRTerm for accessing the robot terminal

Jerry Bransom — Thu, 20 Oct 2022 14:24:35 +0000

This is the way we access the robot programming interface. This program is IP based and similar to HyperTerm

Kawasaki Robot Operation Manual

Jerry Bransom — Thu, 20 Oct 2022 14:19:05 +0000

This manual explains how the Teach Pendant works

Wiring Information for Robot to Machine Interface

Jerry Bransom — Thu, 20 Oct 2022 14:07:13 +0000

Kawasaki Robot External IO Manual for E Controller. If your robot is using DB37 Cables to breakout the IO from the robot, this is the manual for that plus a lot more

EZ SOFTWARE MANUAL

Jerry Bransom — Mon, 27 Jun 2022 16:16:58 +0000

SOFTWARE MANUAL

EZ HARDWARE MANUAL

Jerry Bransom — Mon, 27 Jun 2022 16:16:14 +0000

HARDWARE INSTALL

EZ Touch Editor

Jerry Bransom — Mon, 27 Jun 2022 16:11:41 +0000

Editor Manual – this is the software for programming the PLC we use in our process controller

Kawasaki Robot Spin Control

Jerry Bransom — Sat, 01 Aug 2020 17:36:30 +0000

Kawasaki Robotics Spin Control Function has two control systems. Their differences are listed in the table below.
1. Simple Spin Control: Expands the motion range of JT6 or the external rotation axis set as the spin axis, and synchronizes movement of the spin axis with the other axes (JT1 – JT5) towards the set point. In short, expands the normal motion range for a robot’s JT6 or external rotation axis.

2. Standard Spin Control: Functions the same as Simple Spin Control but without synchronizing movement of the spin axis with the other axes (JT1 – JT5). Uses special commands/instructions for spin control in operation.

Spin Control is more often used in welding robots but can also be used as a safeguard to keep palletizing robots from tearing up the harness on the 4th axis.